Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

301

302

303

304

305

306

307

308

309

310

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Introduced command.

7.7.1.0 Introduced on the C-Series.

Usage

Information

Any update without a MED attribute is the least preferred route.

If you enable this command, use the clear ip bgp * command to recompute the best path.

bgp add-path

Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones.

Syntax

bgp add-path [send | receive | both] path-count

Parameters

send Enter the keyword send to indicate that the system sends multiple paths to peers.

receive Enter the keyword receive to indicate that the system accepts multiple paths

from peers.

both Enter the keyword both to indicate that the system sends and accepts multiple

paths from peers.

path-count

Enter the number paths supported. The range is from 2 to 64.

Defaults Disabled

Command Modes

● ROUTER BGP

● ROUTER BGP-address-family