Users Guide

number ]
[vrfv4acl
number ]
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Clarified block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the
system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks
cannot be reallocated. Only 13 number of blocks can be configured by the user .
There can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors
of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1
Blocks is supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress
Allocate CAM for egress ACLs.
S4820T
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default Reset egress CAM ACL entries to default settings.
Content Addressable Memory (CAM) 411