Users Guide

member-vlan
Specify the member VLAN identification numbers.
S4820T
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by commas), a range of
VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For
example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Combination: 3, 4, 5-10, 8.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
mode
Set the Master or Transit mode of the ring.
S4820T
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keywordtransit to set the Ring node to Transit mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Force10 Resilient Ring Protocol (FRRP) 559