Users Guide

clear dampening
Clear the dampening counters on all the interfaces or just the specified interface.
Syntax
clear dampening [interface]
Parameters
interface (OPTIONAL) Enter any of the following keywords and the interface information to
clear counters from a specified interface:
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Defaults Without an interface specified, the command clears all interface dampening counters.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
After you enter the clear counters command and verify the results with the show interfaces
command, the line rate is not reset to 0.00%.
Example
Dell #clear dampening tegigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
Dell#
Related
Commands
● show interfaces dampening — display interface dampening information.
● dampening — configure dampening on an interface.
614 Interfaces