Users Guide

duplex (10/100 Interfaces)
Configure duplex mode on the Management Interface interfaces where the speed is set to 10/100.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only in one
direction.
full Enter the keyword full to set the physical interface to transmit in both
directions.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with
the speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute the
duplex command.
Related
Commands
● negotiation auto — enable or disables auto-negotiation on an interface.
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on} [negotiate | pause-threshold |
resume-offset]
To return to the default, use the no form of this command.
618 Interfaces