Users Guide

Related
Commands
● interface — configure a physical interface.
● interface loopback — configure a Loopback interface.
● interface port-channel — configure a port channel.
● interface vlan — configure a VLAN.
● ip unreachables — enable generation of internet control message protocol (ICMP) unreachable
messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration).
Using the interface range command, you can enter identical commands for a range of interface.
Syntax
interface range interface {slot/port | port} — port}, interface {slot/port
| port} — port},...
Parameters
interface {slot/
port | port} —
port}, interface
{slot/port | port}
— port},...
Enter interface range and one of the interfaces and then the interface
information. Select the range of interfaces for bulk configuration. You can enter up
to six comma-separated ranges. Spaces are not required between the commas. The
ranges can include VLANs, port-channels, and physical interfaces.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a Tunnel interface, enter the keyword Tunnel then a number from 1 to
16383.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.2.1.0 Added support for 4093 VLANs on E-Series. Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
626 Interfaces