Users Guide

● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
ip ip-address (OPTIONAL) Enter the keyword ip then the IP address of the ARP entry you wish
to clear.
no-refresh (OPTIONAL) Enter the keywords no-refresh to delete the ARP entry from
CAM. Or use this option with interface or ip ip-address to specify which
dynamic ARP entries you want to delete.
NOTE: Transit traffic may not be forwarded during the period when deleted
ARP entries are resolved again and re-installed in CAM. Use this option with
extreme caution.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior limit was 2094).
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
IPv4 Routing 701