Users Guide

● Members can have different Link MTU values. Tagged members must have a link MTU 4 bytes higher
than untagged members to account for the packet tag.
● The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
configured on the VLAN members. For example, the VLAN contains tagged members with Link MTU
of 1522 and IP MTU of 1500 and untagged members with Link MTU of 1518 and IP MTU of 1500. The
VLAN’s Link MTU cannot be higher than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.
The following describes the difference between Link MTU and IP MTU.
Layer 2
Overhead
Difference between Link MTU and IP MTU
Ethernet
(untagged)
18 bytes
VLAN Tag Tag 22 bytes
Untagged Packet
with VLAN-Stack
Header
22 bytes
Tagged Packet
with VLAN-Stack
Header
26 bytes
Related
Commands
● mtu — set the link MTU for an Ethernet interface.
ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.
S4820T
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of name
servers to be used. Separate the addresses with a space.
Defaults No name servers are configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
722 IPv4 Routing