Users Guide

IPv6 Basics
IPv6 basic commands are supported on the Dell Networking OS.
NOTE: For information about the Dell Networking OS version and platform that supports IPv6 in each software feature, see
the IPv6 Addressing section in the Dell Networking OS Configuration Guide.
Topics:
• clear ipv6 fib
• clear ipv6 route
• clear ipv6 mld_host
• maximum dynamic-routes-ipv6
• ipv6 address autoconfig
• ipv6 address
• ipv6 address eui64
• ipv6 control-plane icmp error-rate-limit
• ipv6 flowlabel-zero
• ipv6 host
• ipv6 name-server
• ipv6 nd dad attempts
• ipv6 nd dns-server
• ipv6 nd prefix
• ipv6 route
• ipv6 unicast-routing
• show ipv6 cam stack-unit
• show ipv6 control-plane icmp
• show ipv6 fib stack-unit
• show ipv6 flowlabel-zero
• show ipv6 interface
• show ipv6 management-route
• show ipv6 mld_host
• show ipv6 route
• trust ipv6-diffserv
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a stack unit.
S4820T
Syntax
clear ipv6 fib [vrf vrf-name]| stack-unit unit-number
Parameters
vrf vrf–name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the
neighbor corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are cleared.
slot Enter the slot number to clear the FIB.
unit-number Enter the stack member number. The range is from 0 to 11 for the S4820T.
27
IPv6 Basics 767