Users Guide

lacp port-priority
To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from
aggregating, configure the port priority.
S4820T
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority.
The range is from 1 to 65535. The default is 32768.
Defaults 32768
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
lacp system-priority
Configure the LACP system priority.
S4820T
Syntax
lacp system-priority priority-value
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority.
The range is from 1 to 65535. The default is 32768.
Defaults 32768
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
858 Link Aggregation Control Protocol (LACP)