Users Guide
● EtsAcl : 0
● FcoeAcl : 0
● iscsiOptAcl : 0
● ipv4pbr : 0
● vrfv4Acl : 0
● Openflow : 0
● fedgovacl : 0
● nlbclusteracl: 0
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The
total space allocated must equal to 13. The ipv6acl range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
● 4: Creates 242 entries for use by the OpenFlow controller (256 total entries
minus the 14 entries reserved for internal functionality)
● 8: Creates 498 entries for use by the OpenFlow controller (512 total entries
minus the 14 entries reserved for internal functionality)
Using the fcoe parameter, enter the number of FP groups to be allocated for
FCoE transit. Enter 1 – 6; maximum six groups. Each group has 128 entries,
creating a total of 768 possible entries for FCoE FP groups. The value given must
be an even number.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or
copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks
cannot be reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
88 Control and Monitoring