Owners Manual

Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Example
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
Gi 10/0 656, 658
Gi 10/1 All
Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a
console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either
for all UDP ports or a specified list of UDP ports.
Enhanced Validation of Interface Ranges
This functionality is supported on the S4820T platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as
interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered
valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-
address-table static multicast-mac-address vlan vlan-id output-range interface
command.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on S4820T platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
822
Interfaces