Reference Guide

• If strict priority is applied along with multicast-bandwidth, the effect of strict
priority is on all ports where unicast and multicast bandwidth are applied.
• When multicast bandwidth is assigned along with unicast bandwidth, first
multicast bandwidth is reserved for that port, then the remaining unicast
bandwidth configured is adjusted according to the bandwidth available after
reserving for multicast bandwidth.
queue ingress
Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
S4820T
Syntax
queue ingress multicast {linecard slot number port-set number |
all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard
slot number port-set number | all} [wred-profile name] command.
Parameters
linecard
number
Enter the keyword linecard then the line card slot number.
port-set
number
Enter the keywords port-set then the line card’s port pipe.
The range is from 0 or 1.
all Enter the keyword all to apply to all line cards.
wred-profile
name
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
1366
Quality of Service (QoS)