Reference Guide

Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
You can use this command to configure the group of Radius servers used for
Authentication, Authorization, and Accounting purposes.
If the RADIUS group is not configured for Authentication, Authorization, and
Accounting, then globally configured Radius servers are used for the purposes.
When the RADIUS group is removed, the AAA configuration is also removed.
Example
Dell(conf)#radius-server group group1
Dell(conf-radius-group)#radius-server host 1.1.1.1 key secret
Dell(conf-radius-group)#radius-server host 2.2.2.2 key secret
Dell(conf-radius-group)#radius-server vrf vrf1 source-
interface tengigabitethernet 0/36
Dell(conf)#exit
Dell(conf)#aaa radius group group1
debug radius
View RADIUS transactions to assist with troubleshooting.
S4820T
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1478
Security