Reference Guide

Usage
Information
If the TACACS group is not configured for Authentication, Authorization, and
Accounting, then globally configured TACACS servers are used for the purposes.
When the TACACS group is removed, the AAA configuration is also removed.
Example
Dell(conf)#tacacs-server group group1
Dell(conf-tacacs-group)#tacacs-server host 1.1.1.1 key secret
Dell(conf-tacacs-group)#tacacs-server host 2.2.2.2 key secret
Dell(conf-tacacs-group)#tacacs-server vrf vrf1 source-
interface tengigabitethernet 0/36
Dell(conf)#exit
Dell(conf)#aaa tacacsgroup group1
Related
Commands
aaa authentication login — specifies the login authentication method.
tacacs-server key — configures a TACACS+ key for the TACACS server.
debug tacacs+
To assist with troubleshooting, view TACACS+ transactions.
S4820T
Syntax
debug tacacs+
To disable debugging of TACACS+, use the no debug tacacs+ command.
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Security
1489