Reference Guide

Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
If you configure a VRF for an SSH session, then you need not explicitly mention the
same VRF for the SSH client sessions intended for that VRF. The
vrf attribute in the
ip ssh vrf command is applicable for both the SSH client as well as the COPY
(SCP) commands.
Example
Dell(conf)#ip ssh vrf vrf1
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh vrf vrf1
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
S4820T
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Security
1519