Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command displays the contents of the flash://ADMIN_DIRssh/
knownhosts file.
Example
Dell#show ip ssh client-pub-keys
poclab4,123.12.1.123 ssh-rsa AAAAB3NzaC1yc2EAAAABIwAAAIEAox/
QQp8xYhzOxn07yh4VGPAoUfgKoieTHO9G4sNV+ui
+DWEc3cgYAcU5Lai1MU2ODrzhCwyDNp05tKBU3tReG1
o8AxLi6+S4hyEMqHzkzBFNVqHzpQc
+Rs4p2urzV0F4pRKnaXdHf3Lk4D460HZRhhVrxqeNxPDpEnWIMPJi0
ds= ashwani@poclab4
Dell#
Related
Commands
ip ssh pub-key-file — configures the filename for the host-based authentication.
ssh
Open an SSH connection specifying the host name, username, port number and version of the SSH
client.
S4820T
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ssh [vrf vrf-name] {hostname | ipv4 address | ipv6 address} [-c
encryption cipher | -l username | -m HMAC algorithm | -p port-
number | -v {1 | 2}]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf aand then the name of
the VRF to specify the VRF used with the SSH session.
NOTE: The VRF configured using this command has a
higher precedence than the VRF configured using the ip
ssh vrf
vrf-name command. If you do not configure
a VRF using this command, then the SSH client uses the
configured VRF (if any). If there is a mismatch between
VRFs that are configured using the ip ssh source-
interface command and the ssh vrf vrf-name
command, then an error is reported.
hostname (OPTIONAL) Enter the IP address or the host name of the
remote device.
Security
1525