Reference Guide

igp Enter the keyword igp to match routes originating within
the same AS.
incomplete Enter the keyword incomplete to match routes with
incomplete routing information.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
pre-Version
6.1.1.0
Introduced on the E-Series.
match route-type
To match routes based on the how the route is defined, configure a filter.
S4820T
Syntax
match route-type {external [type-1 | type-2] | internal |
level-1 | level-2 | local}
To delete a match, use the no match route-type {local | internal |
external [type-1 | type-2] | level-1 | level-2}
command.
Parameters
external
[type-1| type-2]
Enter the keyword external then either type-1 or type-2 to
match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal Enter the keyword internal to match only on routes
generated within OSPF areas.
level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.
level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.
local Enter the keyword local to match only on routes generated
within the switch.
282
Access Control Lists (ACL)