Reference Guide

Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
ip community-list — configures community access list.
match community — redistributes routes that match the COMMUNITY attribute.
show ip bgp community — displays BGP community groups.
show ip community-lists — displays configured Community access lists.
set level
To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
S4820T
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1
| level-1-2 | level-2 | stub-area} command.
Parameters
backbone Enter the keyword backbone to redistribute matched routes
to the OSPF backbone area (area 0.0.0.0).
level-1 Enter the keyword level-1 to redistribute matched routes
to IS-IS Level 1.
level-1-2 Enter the keyword level-1-2 to redistribute matched
routes to IS-IS Level 1 and Level 2.
290
Access Control Lists (ACL)