Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric — specifies the metric value assigned to redistributed routes.
set metric-type — specifies the route type assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
S4820T
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Access Control Lists (ACL)
297