Users Guide

-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
------------------------------------------------------------------------
0 Management online S4810 S4810 9.4(0.0) 64
1 Member not present
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
-- Power Supplies --
Unit Bay Status Type FanStatus
---------------------------------------------------------------
0 0 absent absent
0 1 up UNKNOWN up
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
------------------------------------------------------------------
0 0 up up 9120 up 9120
0 1 up up 9120 up 9120
Speed in RPM
Dell(conf)#
Undoing Commands
When you enter a command, the command line is added to the running conguration le (running-cong).
To disable a command and remove it from the running-cong, enter the no command, then the original command. For example, to delete
an IP address congured on an interface, use the
no ip address ip-address command.
NOTE
: Use the help or ? command as described in Obtaining Help.
Example of Viewing Disabled Commands
Dell(conf)#interface tengigabitethernet 2/17
Dell(conf-if-te-2/17)#ip address 192.168.10.1/24
Dell(conf-if-te-2/17)#show config
!
interface TenGigabitEthernet 2/17
ip address 192.168.10.1/24
no shutdown
Dell(conf-if-te-2/17)#no ip address
Dell(conf-if-te-2/17)#show config
!
interface TenGigabitEthernet 2/17
no ip address
no shutdown
Layer 2 protocols are disabled by default. To enable Layer 2 protocols, use the no disable command. For example, in PROTOCOL
SPANNING TREE mode, enter
no disable to enable Spanning Tree.
Obtaining Help
Obtain a list of keywords and a brief functional description of those keywords at any CLI mode using the ? or help command:
• To list the keywords available in the current mode, enter ? at the prompt or after a keyword.
• Enter ? after a command prompt to list all of the available keywords. The output of this command is the same as the help command.
Dell#?
bmp BMP commands
38
Conguration Fundamentals