Users Guide

RIP Conguration Example
The examples in this section show the command sequence to congure RIPv2 on the two routers shown in the following illustration —
Core 2 and Core 3.
The host prompts used in the following example reect those names. The examples are divided into the following groups of command
sequences:
• Conguring RIPv2 on Core 2
• Core 2 RIP Output
• RIP Conguration on Core 3
• Core 3 RIP Output
• RIP Conguration Summary
Figure 110. RIP Topology Example
RIP Conguration on Core2
The following example shows how to congure RIPv2 on a host named Core2.
Example of Conguring RIPv2 on Core 2
Core2(conf-if-te-2/3)#
Core2(conf-if-te-2/3)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Core 2 RIP Output
The examples in the section show the core 2 RIP output.
Examples of the show ip Commands to View Core 2 Information
• To display Core 2 RIP database, use the show ip rip database command.
• To display Core 2 RIP setup, use the show ip route command.
• To display Core 2 RIP activity, use the show ip protocols command.
Routing Information Protocol (RIP)
707