Users Guide

exit Exit from the EXEC
format Format a filesystem
fsck Filesystem check utility
pwd Display current working directory
rename Rename a file
reset Reset selected card
show Show running system information
ssh-peer-stack-unit Open a SSH connection to the peer stack-unit
start Start shell
telnet-peer-stack-unit Open a telnet connection to the peer stack-unit
terminal Set terminal line parameters
upload Upload file
Dell(standby)#
-----------------CONSOLE ACCESS ON A MEMBER----------------------------
Dell(stack-member-1)#?
reset-self Reset this unit alone
show Show running system information
You can connect two units with two or more stacking cables in case of a stacking port or cable failure. Removal of only one of the cables
does not trigger a reset.
Important Points to Remember
• You can stack up to six systems.
• You cannot stack one system with other system types.
• You cannot enable stacking and virtual link trunking (VLT) simultaneously on the device. To convert a stacked unit to VLT, see
Reconguring Stacked Switches as VLT.
• Data ports are congured as stacking ports in predened groups of four 10G ports called stack-groups.
• When using the 40G ports, you can congure a single port as a stack port; each 40G port is a stack-group.
• All stack units must have the same version of Dell Networking OS.
Stacking Installation Tasks
The following are the stacking installation tasks.
• Create a Stack
• Add Units to an Existing Stack
• Split a Stack
Create a Stack
Stacking is enabled on the device using the front end ports.
No conguration is allowed on front end ports used for stacking. Stacking can be made between 10G ports of two units or 40G ports of
two units. The stack links between the two units are grouped into a single LAG.
Stack Group/Port Numbers
By default, each unit in Standalone mode is numbered stack-unit 0.
A maximum of eight 10G stack links or two 40G stack links can be made between two units in a stack. The front end ports are divided into
16 stack groups, each with 40G of bandwidth. Stack groups 0 through 11 correspond to 10G stack groups with four ports each. Stack
groups 12 to 15 are one 40G port each.
The front end ports accommodate SFP, SFP+ and QSFP+.
818
Stacking