Users Guide
Executing IEEE compatible Spanning Tree Protocol
Root ID Priority 0, Address 90b1.1cf4.9b79
Root Bridge hello time 2, max age 20, forward delay 15
Bridge ID Priority 0, Address 90b1.1cf4.9b79
We are the root of Vlan 1000
Configured hello time 2, max age 20, forward delay 15
Interface Designated
Name PortID Prio Cost Sts Cost Bridge ID PortID
---------- -------- ---- ------ ----------- ------- -------------------- --------
Po 1 128.2 128 188
FWD(vltI) 0 0 90b1.1cf4.9b79 128.2
Po 2 128.3 128 2000 FWD(vlt) 0 0 90b1.1cf4.9b79 128.3
Te 1/10 128.230 128 2000 FWD 0 0 90b1.1cf4.9b79 128.230
Te 1/13 128.233 128 2000 FWD 0 0 90b1.1cf4.9b79 128.233
Interface
Name Role PortID Prio Cost Sts Cost Link-type Edge
---------- ------ -------- ---- ------- ----------- ------- --------- ----
Po 1 Desg 128.2 128 188 FWD 0
(vltI)P2P No
Po 2 Desg 128.3 128 2000 FWD 0 (vlt) P2P No
Te 1/10 Desg 128.230 128 2000 FWD 0 P2P Yes
Te 1/13 Desg 128.233 128 2000 FWD 0 P2P No
Dell#
eVLT Conguration Example
The following example demonstrates the steps to congure enhanced VLT (eVLT) in a network.
In this example, you are conguring two domains. Domain 1 consists of Peer 1 and Peer 2; Domain 2 consists of Peer 3 and Peer 4, as
shown in the following example.
In Domain 1, congure Peer 1 st, then congure Peer 2. When that is complete, perform the same steps for the peer nodes in Domain 2.
The interface used in this example is TenGigabitEthernet.
914
Virtual Link Trunking (VLT)