Owners Manual

Table Of Contents

LINE mode

no authentication login no password

9. Save the running-config.

EXEC Privilege mode

copy running-config startup-config

10. Set the system parameters to use the startup configuration file when the system reloads.

uBoot mode

setenv stconfigignore false

11. Save the running-config.

EXEC Privilege mode

copy running-config startup-config

Recovering from a Forgotten Enable Password

Use the following commands if you forget the enable password.

1. Log onto the system using the console.

2. Power-cycle the chassis by switching off all of the power modules and then switching them back on.

3. Hit any key to abort the boot process. You enter uBoot immediately, as indicated by the => prompt.

(during bootup)

hit any key

NOTE: You must enter the CLI commands. The system rejects them if they are copied and

pasted.

4. Set the system parameters to ignore the enable password when the system reloads.

uBoot mode

setenv enablepwdignore true

5. Reload the system.

uBoot mode

reset

6. Configure a new enable password.

CONFIGURATION mode

enable {secret | password}

7. Save the running-config to the startup-config.

EXEC Privilege mode

copy running-config startup-config

Management