Reference Guide

The output of the show file-systems command in the following example shows the total capacity,

amount of free memory, file structure, media type, read/write privileges for each storage device in use.

Dell#show file-systems

Size(b) Free(b) Feature Type Flags Prefixes

520962048 213778432 dosFs2.0 USERFLASH rw flash:

127772672 21936128 dosFs2.0 USERFLASH rw slot0:

- - - network rw ftp:

- - - network rw tftp:

- - - network rw scp:

You can change the default file system so that file management commands apply to a particular device

or memory.

To change the default directory, use the following command.

• Change the default directory.

EXEC Privilege mode

cd directory

Enabling Software Features on Devices Using a Command

Option

This capability to activate software applications or components on a device using a command is

supported on the S4810, S4820T, and S6000, platforms.

Starting with Release 9.4(0.0), you can enable or disable specific software functionalities or applications

that need to run on a device by using a command attribute in the CLI interface. This capability enables

effective, streamlined management and administration of applications and utilities that run on a device.

You can employ this capability to perform an on-demand activation or turn-off of a software component

or protocol. A feature configuration file that is generated for each image contains feature names denotes

whether this enabling or disabling method is available for such features. In 9.4(0.0), you can enable or

disable the VRF application globally across the system by using this capability.

You can activate VRF application on a device by using the feature vrf command in CONFIGURATION

mode.

NOTE: The no feature vrf command is not supported on any of the platforms.

To enable the VRF feature and cause all VRF-related commands to be available or viewable in the CLI

interface, use the following command. You must enable the VRF feature before you can configure its

related attributes.

Dell(conf)# feature vrf

Based on whether VRF feature is identified as supported in the Feature Configuration file, configuration

command feature vrf becomes available for usage. This command will be stored in running-configuration

and will precede all other VRF-related configurations.

NOTE: The MXL and Z9000 platforms currently do not support VRF. These platforms support only

the management and default VRFs, which are available by default. As a result, the feature vrf

command is not available for these platforms.

Getting Started