Reference Guide

mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address
changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a
given interval.
S4820T
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold
number
Enter the keyword threshold then the number of times
MAC addresses in VLANs can change before an SNMP trap is
sent. The range is from 1 to 10.
interval
seconds
Enter the keyword interval then the number of seconds.
The range is from 5 to 60.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
For information about the specific trap sent and the corresponding Syslog, refer to
the SNMP Traps chapter.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
S4820T
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command
Modes
CONFIGURATION
1036
Layer 2