Reference Guide

debug ip msdp
Turn on MSDP debugging.
S4820T
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted
decimal format (A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted
decimal format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
S4820T
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{
number} command.
1106
Multicast Source Discovery Protocol (MSDP)