Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced
Usage
Information
Modifications to the ACL do not have an immediate effect on the sa-cache.
To apply the redistribute filter to entries already present in the SA cache, use the
clear ip msdp sa-cache local command.
ip msdp sa-filter
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the
specified peer.
S4820T
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list
name]
Remove this configuration using the no ip msdp sa-filter {in | out}
peer address list [access-list name] command.
Parameters
in Enter the keyword in to enable incoming SA filtering.
out Enter the keyword out to enable outgoing SA filtering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
access-list
name
Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Multicast Source Discovery Protocol (MSDP)
1113