Reference Guide

Parameters
conditional
nvram-cfg-
change
Reload if the condition is true. A configuration change to the
nvram requires a switch reload. To reload the switch, select
nvram-cfg-change.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version 9.1(0.0) Added ‘conditional’ parameter.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If there is a change in the configuration, FTOS prompts you to save the new
configuration. Or you can save your running configuration with the copy
running-config command. Use the conditional parameter if any configuration
changes made to the nvram, such as stack-group and fanout configurations, must
be saved.
send
Send messages to one or all terminal line users.
S4820T
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty
lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword console to send a message to the
primary terminal line.
122
Control and Monitoring