Reference Guide

show inventory
Display the S-Series or Z-Series switch type, components (including media), and Dell Networking
Operating System (OS), including hardware identification numbers and configured protocols.
S4820T
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of
the stack member for which you want to display pluggable
media inventory.
NOTE: This parameter is available but not supported in
Dell Networking Operating System version 8.3.11.4.
Because stacking is not supported, if you use this
parameter, the output displays “Media not present or
accessible” (refer to the Usage Information section).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4
optics.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced this version of the command for S-Series. S-
Series output differs from E-Series.
Usage
Information
If there are no fiber ports in the unit, just the header under show inventory media
displays. If there are fiber ports but no optics inserted, the output displays Media
not present or accessible.
Example
(S6000)
Dell#show inventory
System Type : S6000
System Mode : 1.0
Software Version : 9-4(0-168)
134
Control and Monitoring