Reference Guide

ip-
precedence-list
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 7.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added support for the ipv6 and ip-any options on the Z9000,
S6000, S4820T, S4810, MXL.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the match ip
precedence 0-3
or match ip precedence 0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
Related
Commands
class-map — identifies the class map.
Quality of Service (QoS)
1347