Reference Guide

maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of
queues. The WRED Curve is applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue
ingress. If you attempt to use the
multicast-bandwidth option, the
following reject error message is generated: % Error:Bandwidth-percent
is not allowed for ingress multicast.
rate-police
Specify the policing functionality on incoming traffic.
S4820T
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
Quality of Service (QoS)
1357