Reference Guide

tacacs-server key — configures a TACACS+ key for the TACACS server.
tacacs-server host
Specify a TACACS+ host.
S4820T
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname Enter the name of the TACACS+ server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the TACACS+ server host.
port number (OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is 49.
timeout
seconds
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
key key
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.4.1.0 Added support for IPv6.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Authentication key length increased to 42 characters.
Version 7.6.1.0 Introduced on the S-Series.
Security
1487