Reference Guide

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
The source-interface interface attribute is applicable for both the SSH
client
as well as the COPY (SCP) commands. Using these attributes the client
session tags an error to the user during run time, in case there is a mismatch
between this command and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 0/36
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
ip ssh server
Configure an SSH server. SSH server is enabled by default.
S4820T
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ip ssh server {ciphers cipher-list} {enable | port port-number}
[kex key-exchange-algorithm] [mac hmac-algorithm] [version {1 |
2}]
To disable SSH server functions, use the no ip ssh server {ciphers
cipher-list} {enable | port port-number} [kex key-exchange-
algorithm
] [mac hmac-algorithm] [version {1 | 2}] command.
Parameters
enable Enter the key word enable to start the SSH server.
ciphers cipher-
list
Enter the keyword ciphers and then a space-delimited list
of ciphers that the SSH server supports.
The following ciphers are available.
• 3des-cbc
• aes128-cbc
• aes192-cbc
• aes256-cbc
• aes128-ctr
1516
Security