Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command enables the SSH server and begins listening on a port. If a port is
not specified, listening is on SSH default port 22.
NOTE: Starting with Dell Networking OS Release 9.2(0.0), SSH server is
enabled by default.
Example
Dell# conf
Dell(conf)# ip ssh server port 45
Dell(conf)# ip ssh server enable
Dell#
Related
Commands
show ip ssh — displays the ssh information.
ip ssh server vrf
Configure an SSH server on either a specific VRF or a management VRF.
S4820T
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ip ssh server vrf {management | vrf-name}
To disable the SSH server configuration, use the no ip ssh server vrf
{management | vrf-name}
command.
Parameters
vrf
management
Enter the key word vrf followed by the keyword
management to configure an SSH server on a management
VRF.
vrf vrf-name Enter the key word vrf followed by the VRF name to
configure an SSH server on that VRF.
Defaults None
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Security
1519