Reference Guide

snmp-server user
Configure a new user to an SNMP group.
S4820T
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-
name udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5
| sha} auth-password] [priv des56 priv password] [access
access-list-name | ipv6 access-list-name | access-list-name
ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name
{group_name remote ip-address vrf vrf-name udp-port port-
number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-
password] [priv des56 priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]
command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on
the host that connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro
permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-
address
Enter the keywords udp-port then the user datagram
protocol (UDP) port number on the remote device. The
range is from 0 to 65535. The default is 162.
vrf vrf-name Enter the keywords vrf and then the name of the VRF this is
used to connect to the SNMP server.
NOTE: Use this attribute to specify a VRF name that is
used to connect to the remote host. If no VRF is
specified, then the default VRF is used.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram
Protocol) port number on the remote device. The range is
from 0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c,
or
3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which
allows for integers twice the width of what is normally
allowed.
1576
Simple Network Management Protocol (SNMP) and Syslog