Reference Guide

Parameters
stp-id Enter zero (0). The switch supports one spanning tree group
with a group ID of 0.
protocol Enter the keyword for the type of STP to debug, either mstp,
pvst, or rstp.
all (OPTIONAL) Enter the keyword all to debug all spanning
tree operations.
bpdu (OPTIONAL) Enter the keyword bpdu to debug bridge
protocol data units.
config (OPTIONAL) Enter the keyword config to debug
configuration information.
events (OPTIONAL) Enter the keyword events to debug STP
events.
general (OPTIONAL) Enter the keyword general to debug general
STP operations.
root (OPTIONAL) Enter the keyword root to debug STP root
transactions.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the
software only sends information on BPDUs for the last interface specified.
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
Spanning Tree Protocol (STP)
1633