Reference Guide

interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults Not enabled.
Command
Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added the monitor option.
Usage
Information
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
permit — configures a MAC address filter to pass packets.
seq — configures a MAC address filter with a specified sequence number.
mac access-list standard
To configure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter
MAC ACCESS LIST mode. Also refer to the Commands Common to all ACL Types section and the
Common MAC Access List Commands section.
S4820T
Syntax
mac access-list standard mac-list-name
250
Access Control Lists (ACL)