Reference Guide

To delete a MAC access list, use the no mac access-list standard mac-
list-name command.
Parameters
mac-list-name Enter a text string as the name of the standard MAC access
list (140 character maximum).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
Access Control Lists (ACL)
251