Reference Guide

seq
To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number.
S4820T
Syntax
seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge
min-prefix-length} {le max-prefix-length}] | [bitmask number]
To delete a specific filter, use the no seq sequence-number {deny |
permit} {any} | [ip-prefix {ge min-prefix-length} {le max-
prefix-length}] | [bitmask number].
Parameters
sequence-
number
Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition..
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prefix /nn (OPTIONAL) Specify an IP prefix in the network/length
format. For example, 35.0.0.0/8 means match the first 8 bits
of address 35.0.0.0.
ge min-prefix-
length
(OPTIONAL) Enter the keyword ge and then enter the
minimum prefix length, which is a number from zero (0) to
32.
le max-prefix-
length
(OPTIONAL) Enter the keyword le and then enter the
maximum prefix length, which is a number from zero (0) to
32.
bitmask
number
Enter the keyword bitmask then enter a bit mask number in
dotted decimal format.
Defaults Not configured.
Command
Modes
PREFIX-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Access Control Lists (ACL)
267