Reference Guide

Usage
Information
If you do not use the set weight command, router-originated paths have a
weight attribute of 32768 and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
S4820T
Syntax
show config
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
Dell(config-route-map)#show config
!
route-map hopper permit 10
Dell(config-route-map)#
show route-map
Display the current route map configurations.
S4820T
Syntax
show route-map [map-name]
Parameters
map-name (OPTIONAL) Enter the name of a configured route map, up
to 140 characters.
Access Control Lists (ACL)
297