Reference Guide

If the route is injected via the network command, that route still appears in the
routing table if the summary-only parameter is configured in the aggregate-
address
command.
The summary-only parameter suppresses all advertisements. If you want to
suppress advertisements to only specific neighbors, use the
neighbor
distribute-list command.
In the show ip bgp command, aggregates contain an ‘a’ in the first column and
routes suppressed by the aggregate contain an ‘s’ in the first column.
When an aggregate address is denied using a peer's outbound route-map,
individual routes suppressed by the aggregate address are advertised to that peer.
The attribute-map corresponding to an aggregate address is applied during the
outbound update creation time; hence the value set in that attribute-map will not
be shown in the output of the show ip bgp aggregate route command.
bgp always-compare-med
Allows you to enable comparison of the MULTI_EXIT_DISC (MED) attributes in the paths from different
external ASs.
S4820T
Syntax
bgp always-compare-med
To disable comparison of MED, enter no bgp always-compare-med.
Defaults Disabled (that is, the software only compares MEDs from neighbors within the
same AS).
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced command.
Version 7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol
379