Reference Guide

show ip bgp community-list
View routes that a specific community list affects.
S4820T
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] community-list
community-list-name [exact-match]
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view routes affected by a specific community list
corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
community-
list-name
Enter the name of a configured IP community list (maximum
140 characters).
exact-match Enter the keyword for an exact match of the communities.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The show ip bgp community-list command without any parameters lists BGP
routes matching the Community List and the output is the same as for the show
ip bgp
command output.
The following describes the show ip bgp community-list pass command
shown in the following example.
456
Border Gateway Protocol