Reference Guide

Defaults none
Command
Modes
ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
If the set community rt and soo are in the same route-map entry, the behavior
defines as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities rt sets.
• If the rt option comes after soo, without the additive option, rt overrides
the communities
soo sets.
• If the rt with the additive option comes after soo, rt adds the communities
soo sets.
Related
Commands
set extcommunity rt — sets the extended community route origins using the route-
map.
show ip bgp ipv4 extcommunity-list
To display the IPv4 routes matching the extended community list name, use this feature.
Syntax
show ip bgp [ipv4 [multicast | unicast] | ipv6 unicast]
extcommunity-list name
Parameters
multicast Enter the keyword multicast to display the multicast route
information.
unicast Enter the keyword unicast to display the unicast route
information.
ipv6 unicast Enter the keywords ipv6 unicast to display the IPv6
unicast route information.
492
Border Gateway Protocol