Reference Guide

clear ip bgp ipv6 unicast soft
Clear and reapply policies for IPv6 unicast routes without resetting the TCP connection; that is, perform
BGP soft reconfiguration.
S4820T
Syntax
clear ip bgp {* | as-number | ipv4-neighbor-addr | ipv6-
neighbor-addr | peer-group name} ipv6 unicast soft [in | out]
Parameters
* Clear and reapply policies for all BGP sessions.
as-number Clear and reapply policies for all neighbors belonging to the
AS. The range is from 0 to 65535 (2 Byte), from 1 to
4294967295 (4 Byte), or from 0.1 to 0.65535.65535 (Dotted
format).
ipv4-neighbor-
addr | ipv6-
neighbor-addr
Clear and reapply policies for a neighbor.
peer-group
name
Clear and reapply policies for all BGP routers in the specified
peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
Version 7.8.1.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced on the E-Series TeraScale.
496
Border Gateway Protocol