Reference Guide

Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.0
Introduced on the S4810.
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
S4820T
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-
name
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Defaults Disabled.
Command
Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address
families.
498
Border Gateway Protocol