Reference Guide

To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• dcb-input — creates a DCB PFC input policy.
• dcb-policy input — applies the output policy.
• dcb-output — creates a DCBETS output policy.
• dcb-policy output — applies the output policy.
ets mode on
Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output
policy or received in a DCBX TLV from a peer can take effect on an interface.
S4820T
Syntax
ets mode on
To remove the ETS configuration, use the no ets mode on command.
Defaults ETS mode is on.
Command
Modes
DCB OUTPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
542
Data Center Bridging (DCB)