Reference Guide

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
If you disable ETS in an output policy applied to an interface using the no ets
mode on command, any previously configured QoS settings at the interface or
global level takes effect. If you configure QoS settings at the interface or global
level and in an output policy map (the
service-policy output command), the
QoS configuration in the output policy takes precedence.
ETS configurations are accepted from the local and remote system and take effect
based on DCBX negotiations.
Related
Commands
• dcb-output — creates a DCB output policy.
• dcb-policy output — applies the output policy.
priority-list
Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
S4820T
Syntax
priority-list value
To remove the priority list, use the no priority-list command.
Parameters
value Enter the priority list value. Separate priority values with a
comma; specify a priority range with a dash; for example,
priority-list 3,5-7. The range is from 0 to 7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Data Center Bridging (DCB)
543