Reference Guide

netbios-name-server
Specify the NetBIOS Windows Internet Naming Service (WINS) name servers, in order of preference, that
are available to Microsoft Dynamic Host Configuration Protocol (DHCP) clients.
S4820T
Syntax
netbios-name-server address [address2...address8]
Parameters
address Enter the address of the NETBIOS name server. You may
enter up to eight, in order of preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
netbios-node-type
Specify the NetBIOS node type for a Microsoft DHCP client. Dell Networking recommends specifying
clients as hybrid.
S4820T
Syntax
netbios-node-type type
Parameters
type Enter the NETBIOS node type:
• Broadcast: Enter the keyword b-node.
• Hybrid: Enter the keyword h-node.
• Mixed: Enter the keyword m-node.
• Peer-to-peer: Enter the keyword p-node.
Defaults Hybrid
620
Dynamic Host Configuration Protocol (DHCP)